Recently so many people meet this problem ,after they use the cat caterpillar ET Diagnostic Adapter 3 to connect with the vehicle, the light could not turn on and could not work. How to solve this problem?
Change the all new CAT Caterpillar ET Diagnostic Tool ,the result is same .
After we checked the CAT vehicle ‘s diagnostic seat, then find the question .
the reason is that there is some cat vehicle’s diagnostic seat is not standard, and that is not matched with our 9 pin diagnostic connector .
some people cat vehicle the diagnostic seat picture as following :
our CAT Caterpillar ET Diagnostic Tool 9 pin connecter picture as following :
pls check ( the left is the vehicle diagnostic seat .and the right is cat device 9 pin connecter .
Vehicle connection is:
A – Battery Negative
B – Battery Positive
C – J1939 Data Link+
D – J1939 Data Link-
E – J1939 Shield
F – J1587 Data Link+
G – J1587 Data Link-
H – not connected
J – not connected
CAT Diagnostic Tool 9PIN Cable is ：
A – Battery Positive
B – Battery Negative
C – J1587 Data Link+（J1708 Data Link+）
D – J1587 Data Link-（ J1708 Data Link-）
E– J1939 Data Link+
F – J1939 Data Link-
G – CDL+
H – CDL-
J（I） – not connected
Some CAT Vehicle diagnostic seat is not match with our cat device 9 pin connecter . Even the positive and negative poles of the power supply are opposite ,so our 9 pin diagnostic connect with the vehicle seat ,could not get the power and the device could not work .
How to solve such problems:
so when you use the cat device 9 pin connecter to connect with the vehicle seat .you need connect the corresponding ports, like this ,the device can get the power then could test the vehicle.