Yes it is 100% sure that Auto Diagnostic tool Renault CAN CLIP software is compatible with Nissan Consult III hardware. This is verified by many experienced users.
Therefore, the CAN Clip and Nissan Consult 3 2-in-1 interface is developed, which is only $130 and more cost-effective. It looks like this:
Refer to others feedback is more trustful, following are 4 pieces of feedback.
NOTE: you will be at risk to try this.
Feedback 1:
Yes it will work with both, it is alliance B
Do not but the ones flying around with the WHITE < <16 PIN CONNECTOR.
As regards programming, I’m unsure because I never tested, However there are can clip interfaces that are alliance B and they work fine.
Feedback 2:
If that is recognized as VI alliance by drivers this will work with Clip and Consult too
I’d say that there is very high chance of success.
Feedback 3:
Nissan consult 3 is verified working fine with Nissan and Renault cars, while there is only Nissan software come with the interface, you need to buy Renault software extra.
Feedback 4:
Worked perfectly with Nissan and Renault CAN Clip Diagnostic Interface.
It is risky to start with this hardware, for example, flashing the control unit of the vehicle. That’s why I at first was looking for the original hardware, or really good clone. I know that there are good clones. I had one good clone can clip with Full Chip AN2135SC AN2136SC in the below picture.
Leave a Reply