How to use Autel MaxiIM IM508 to add smart remote for Subaru XV GT Edition 2021 via OBD？
The original Subaru chip is 8A RF430 433.92 MHZ FSK
Turn ignition on
Then operate on IM508 tablet (same procedure as OtoSys IM100)
Select Subaru>> Manual Selection>> Asia>> XV>> 2012-2020>> Smart key
Confirm the vehicle info detect out
Tap ‘IMMO Status Scan’
The number of registered keys is 2
Tap ‘Add keys (guided)’
Establishing vehicle communication…
Press ‘Start’ to add new key
Confirm to enter key learning (adding) procedure
Make sure all doors are in current positions during the learning period
Take the registered key (original) key close to the Start button
After hear 1 beep, put the key to passenger seat
Success
Then take the new key to be learnt close to start button
After all keys have been registered (also hear 1 beep on the new key), press ‘OK’
Now the number of registered keys is 3.
Turn off ignition button
Use the keys have been learnt to turn on ignition within 60 seconds
Program successfully
Finally, use the new key to start the car and test the remote, both OK.
Autel MaxiIM IM608/IM508 XP400 currently supports following 2020/2021 Subaru IMMO & Smart all keys lost programming models:
Forester 2013-2021 (Immobilizer)
Forester 2013-2021 (Keyless System)
Impreza WRX 2015-2021 (Immobilizer)
Forester 2013-2021 (Keyless System)
Legacy 2013-2021 Keyless System
Legacy 2013-2021 Immobilizer (Without IMMO)
Levorg 2015-2020 Immobilizer
Levorg 2015-2020 Keyless System
Outback 2013-2021 Keyless System
Outback 2013-2021 Immobilizer (Without IMMO)
WRX 2015-2020 Keyless System
WRX 2015-2020 Immobilizer
Crosstrek 2012-2021 Immobilizer
Crosstrek 2012-2021 Keyless System
Impreza 2012-2021 Immobilizer
Impreza 2012-2021 Keyless System
Liberty 2015-2021 Immobilizer
Liberty 2015-2021 Keyless System
XV 2012-2021 Immobilizer
XV 2012-2021 Keyless System
XV Crosstrek 2012-2021 Immobilizer
XV Crosstrek 2012-2021 Keyless System
For the 2020/2021 Subaru Smart Key AKL programming guide using IM608/IM508, please pay attention to the following notes:
Don’t need online subscription.
Network connection is required. It’s all by OBD
You can use OEM, aftermarket, used new, old as long as it looks the same.
They do lock but can be reset, not every device will do them, but some can. HYQ14AHK.
Better use APB112 emulator key. If you don’t have APB112, you can do reset procedure. 2 steps: Just reset smart box and then add key.
Leave a Reply