Solve KT200 Software Update Failure Problem

There have  Two Ways to Solve KT200 Software Update Failure Problem!

When you open KT200/KTM200 and prompt you to update the version with the words ‘New version found, start updating’, after clicking OK, there is no response, and cannot update the new version automatically, just download and install the driver/patch by www.cnautotool.com engineer provided in this post, and the problem will be resolved soon.

 

Method 1: Free download KT200 V2022.10.01 software (new):

https://mega.nz/file/ONYEDYyK#7M1W1dBjjx50Xp6sqC9kcO0uD1GDMO_CgntOi7fkOBg

Size: 910.5 MB

Note: the software version is the same as before, but the factory has fixed the bug that software flash and not open problem.

 

Important tips to install KT200 software:

DO NOT connect KT200 ECU programmer, go to run renew driver64.exe directly
Connect KT200 and computer via USB cable, then run Updatefirmware.exe

Note: Don’t disconnect USB during the process

Install setup.exe, then run KT200.exe

 

Method 2: Free download the latest KT200 patch and dfb2xx.ll

https://mega.nz/file/Mbs3XBwY#Ia3erk1QfYFLk5P8fO9JlU3rHBK5fE2Smo2oXGuG0Zo

Size: 40.4MB

 

Installation steps:

Unzip the files downloaded

Load and install the Patch SP20221024 (1)

Click install, then all select YES

Copy dfb2xx.dll to replace the specified folder file

Copy and paste dfb2xx.dll to C:/KT200-master/DFBTech_Driver/i386 folder

For the 32 bit system: copy and paste dfb2xx.dll to C:/Windows/System32 folder

For the 64 bit system: copy the dfb2xx.dll file to C:/Windows/SysWOW64 folder

Alright, KT200 software update process is done by the two methods above, and the new version software can be used normally.

 

Add a Comment

Your email address will not be published. Required fields are marked *