How to Use Lonsdor K518ISE for The First Time

Before using Lonsdor K518ISE key programmer, you need first of all to set WIFI when you turn on the device, then go through the registration&activation process, make sure well connection between the device, OBD cable and the vehicle under proper circumstance.

Lonsdor K518ise Operation detail steps:

First time to start Lonsdor K518ise, please set the network (connect available WIFI).

After networking, the system will automatically updated to the latest version. There are 3
ways of system update:

1.One key update: quickly update the new added or modified functions.
2.APK update: this is used when the APK is updated.
3.Registration & activation

After Lonsdor K518ise from www.cnautotool.com system updating, you need go to registration&activation. For new user, click Registration, input user name(email), name(min 2 char), password(min 6 char), email verification code and click YES to complete registration(if interrupted after registration is done, you will go to the System update–Registered user to proceed). Then go to Activation confirmation to continue.

After confirming activation, it will enter into Setup password interface, please set 6-digit numbers as your startup password. Then after information verification by Key Programmer Lonsdor (5-30 minutes, you can check the progress by clicking “Refresh” ), you will required to re-enter the password to verify, when you get the notification that verification successful, the whole process before using the device is complete.

Be the first to comment

Leave a Reply

Your email address will not be published.


*