How to Setup BMW ICOM WIFI D-link?

The new version of BWM ICOM A2+B+C diagnostic & programming tool is equipped with WIFI and a router. Following easy and important steps leads you to the correct way on configuring ICOM WIFI USB D-link and enabling WIFI wireless function.
1.1
Computer Requirement:

Almost 95% laptops on the world with Intel chip (I3/I5/I7 series) and have 4GB memory
How to Install/Configure BMW ICOM USB WIFI D-link?

1. Insert WIFI USB D-link into the computer via USB port
1.2
2. Turn off the computer built-in WIFI or additional WIFI resources. Make sure only BMW ICOM WIFI USB exist on the computer. Meanwhile, disable both Internet network and local area connection.

3. Then power on computer.

4. Open “Network Connections” program to check there is no other existing Internet and Local Area connection.

Note: Do not disable DWA-131 which is the ICOM WIFI USB. If it displays “X” mark, ignore it.
1.3
5. Run BMW ICOM Rheingold ISTA-D ISTA-P software, tick “WIFI for ICOM”
1.4
6. Connect BMW ICOM A2 emulator connector with vehicle. Wait 20-60 seconds until the BMW ICOM A2 WLAN indicator stops flashing or flashes slowly which indicates that well communication is built between WIFI USB adapter and BMW ICOM A2 WIFI.
1.5
7. Start using BMW ICOM ISTA-D diagnostic or ISTA-P programming software. Press OK to continue.
1.6
8. The ISTA-D, ISTA-P, ISPI, ISSS etc program cannot be turn off, but only be miniaturized.
1.7
9. The WIFI BMW ICOM diagnostic system device is recognized by computer. WIFI wireless diagnostic and programming function are activated.
1.8

 

BMW ICOM A2 Diagnostic Tool With V2020.08 Engineers Software BMW Scan Tool Plus EVG7 Tablet PC Ready to Use
BMW ICOM NEXT BMW ICOM A2 A+B+C Plus Lenovo X220 I5 4GB Laptop V2020.08 Engineers Version Ready to Use

Be the first to comment

Leave a Reply

Your email address will not be published.


*